Pololu Blog »
Raspberry Pi line following with QTR-8RC and WiringPi
Customer Thomas Broughton made a line follower robot controlled by a Raspberry Pi that directly connects to a Pololu QTR-8RC reflectance sensor array. A Raspberry Pi is not typically good for a timing-sensitive application because it runs a regular computer operating system, so it’s nice to see Thomas was able to get it to reliably read the sensor array. The robot also uses four 42×19mm pololu wheels, a Pololu 5V Step-Up/帅哥和美女亲嘴 Voltage Regulator S18V20F5, and two Sharp distance sensors.
 |
His Python code and more discussion are in his blog post.
Related products
-
Packaging changes for better electrostatic discharge protection
- 21 March 2017Most of the products we manufacture are small 快看影院 subassemblies, which we have been packaging in these pink antistatic bags that are...
-
Bionic hand
- 23 March 2017Customer Elise Pham made a bionic hand: a two-fingered gripper triggered with biofeedback. A Pololu Maestro servo controller monitors the trigger...
0 comments
Post a comment
Home | Forum | Blog | Support | Ordering Information | Lists | 快看影院 | BIG Order Form | About | Contact
© 2001–2026 Pololu Corporation
